HomeLightning & Surges ProtectionElectronic Systems Protection › Furse ESP PCB/D and PCB/TN Series


Furse ESP PCB/D and PCB/TN Series


Combined Category D, C, B tested protector (to BS EN 61643-21) for "through hole" mounting directly onto the PCB of data communication, signal or telephone equipment. Available for working voltages of up to 110V. ESP TN suitable for Broadband, POTS, dial-up, T1/E1, lease line and *DSL telephone applications. For use at boundaries up to LPZ 0A to protect against flashover (typically the service entrance location) through to LPZ 3 to protect sensitive electronic equipment.

Features and Benefits

  Suitable for wave soldering
  Very low let-through voltage (enhanced protection to BS EN 62305) between all lines - Full Mode protection
  Full mode design capable of handling partial lightning currents as well as allowing continual operation of protected equipment
  Repeated protection in lightning intense environments
  Low in-line resistance minimises unnecessary reductions in signal strength
  2 pin clean end and 3 pin line end to ensure correct insertion
  ESP PCB/TN is suitable for telecommunication applications in accordance with Telcordia and ANSI Standards (see Application Note AN005)


Data Sheet



Installation

Connect in series, soldering pins direct onto PCB. Tracks to line and earth pins should be as wide as practical (see Furse Application Note AN003).

Models

  ESP PCB/06D
  ESP PCB/15D
  ESP PCB/30D
  ESP PCB/50D
  ESP PCB/110D
  ESP PCB/TN

Please note - Product designs and specifications are subject to change without notice. The user is responsible for determining the suitability of this product.

Back To Last Page

Furse


Earthing & Lightning Protection

Electronic Systems Protection (ESP Range)

Furseweld

Ty-Met Stainless Steel Cable Ties

Archive Information

Archive Furse Information


Want A Quotation?

Please fill out the following fields and we will e-mail you a quotation shortly.