Menu

Home › Gas Analysers › Safety › Drager Polytron 5200


Drager Polytron 5200


Quick, reliable and cost-effective detection of combustible gases and vapors in ambient air: the microprocessor-based transmitter is the result of more than 40 years of experience in measurement technology. In addition, the CatEx sensor of the Polytron 5200 DD can be replaced with a more poison-resistant IR sensor, upgrading the Polytron 5200 DD to an IR device (Polytron 5310).

PROVEN - AND STILL GETTING BETTER: DRï¿œGER MEASUREMENT TECHNOLOGY

Drager has been developing and manufacturing sensors and gas detectors for industrial use for more than 40 years. And with each new generation, we drive our measurement technology a bit further. With the Polytron 5200, you will definitely benefit from this experience and power of innovation. Its new DragerSensor Ex PR DD or Ex PR LC, for example, ensures:

  Longer lifetime
  Better poison resistance
  Extremely high sensitivity
  Short response times
  High accuracy
  Stable sensor signal

OPTIONAL: THREE RELAYS FOR CONTROLLING EXTERNAL EQUIPMENT

Upon request, the Drager Polytron 5200 can be supplied with three integrated relays. This enables you to use it as an independent gas detection system with two arbitrarily adjustable concentration alarms and one fault alarm. Audio alarms, signal lights, or similar devices can, thus, be controlled locally - without an additional cable between the transmitter and a central controller. The sensor signal can be evaluated using the 4 to 20 mA signal.

OPTIONAL: TWO MOUNTING SETS FOR EASY FLANGE-MOUNTING

The housing has four mounting holes. Two different mounting sets are available for installing the Polytron 5200: a duct-mount and a pipe mount set. This means that the transmitter can be easily installed anywhere - e.g., on a smooth wall, a pipe or an exhaust duct.



Get a Quote

QUICK AND EASY WIRING

The electronics and the bezel form a single unit. Simply pull them out of the housing. Then insert the three-wire cable into the terminals - either through the Ex-e cable gland or through the seal on the conduit. Finally, plug the terminal block into the PCB.

FURTHER ADVANTAGES:

  Available as flameproof or increased safety version
  Aluminum or 316 L stainless steel housing for the most extreme industrial conditions
  Extremely user-friendly software thanks to a minimum number of menu items
  Backlit display: easy to read, even in the dark and without a flashlight
  Traffic light status indicators (green = no danger, yellow = error, flashing red = gas alarm)
  Can also be used as an early warning system (0-10 % LEL) for ammonia


Datasheet

Ordering Information


Without relays (DD) 4544150 (Aluminum 'd')

Without relays (DD) 4544152 (SS316L 'd')

Without relays (LC) 4544130 (Aluminum 'd')

Without relays (LC) 4544132 (SS316L 'd')

With relays (DD) 4544151 (Aluminum 'd')

With relays (DD) 4544153 (SS316L 'd')

With relays (LC) 4544131 (Aluminum 'd')

With relays (LC) 4544133 (SS316L 'd')



Drager

Please note - Product designs and specifications are subject to change without notice. The user is responsible for determining the suitability of this product.

Back To Last Page