Home › Gas Analysers › Safety › Drager Polytron 5700
Drager Polytron 5700
Quick, reliable and cost-effective detection of combustible gases
and vapors in ambient air: the microprocessor-based transmitter
is the result of more than 40 years of experience in measurement
technology and contains a new, innovative IR sensor with drift-free
optics. These optics are extremely resistant against deposits and
insects in the beam. PROVEN - AND STILL GETTING BETTER: DRï¿œGER MEASUREMENT TECHNOLOGY
Drager has been developing and manufacturing
sensors and gas detectors for
industrial use for more than 40 years. And
with each new device generation, we drive
our measurement technology a bit further.
With the Polytron 5700, you will definitely
benefit from this experience and power of
innovation. Its sensors are based on an
open, double-compensated optical infrared
system. This innovative design offers
the following advantages: LIBRARY CONTAINING UP TO 100 GASES (TYPES 334 AND 340): Each of the gases listed there can, for example, be cross-calibrated with vapors and preset gases, such as methane or propane. All calculations and linearizations are performed automatically. OPTIONAL: TWO MOUNTING SETS FOR EASY FLANGE-MOUNTING The housing has four mounting holes. Two different mounting sets are available for installing the Polytron 5700: a duct-mount and a pipe mount set. This means that the transmitter can be easily installed anywhere - e.g., on a smooth wall, a pipe or an exhaust duct. |
OPTIONAL: THREE RELAYS FOR CONTROLLING EXTERNAL EQUIPMENT Upon request, the Drager Polytron 5700 can be supplied with three integrated relays. This enables you to use it as an independent gas detection system with two arbitrarily adjustable concentration alarms and one fault alarm. Audio alarms, signal lights, or similar devices can, thus, be controlled locally - without an additional cable between the transmitter and a central controller. The sensor signal can be evaluated using the 4 to 20 mA signal. QUICK AND EASY WIRING The electronics and the bezel form a single unit. Simply pull them out of the housing. Then insert the three-wire cable into the terminals - either through the Ex-e cable gland or through the seal on the conduit. Finally plug the terminal block into the PCB. FURTHER ADVANTAGES:
|
short response times
Please note - Product designs and specifications are subject to change without notice. The user is responsible for determining the suitability of this product.