Menu

Home › Gas Analysers › Safety › Drager Polytron TX


Drager Polytron TX


This product is now obsolete and has been replaced by the Polytron 5000.

The Drager Polytron TX is an economical, microprocessor-based gas detector for continuous monitoring of toxic gases and oxygen in ambient air. Non-intrusive calibration and maintenance is performed using a magnetic wand to access the software through the enclosure window - no need to open the enclosure (and obtain special area permits) to perform routine calibrations.

Easy to install

The enclosure provides two mounting holes. For easy wiring, bezel and electronics is one unit, and can be pulled out. The two wire cable, fed through a sealed conduit, is terminated in a pluggable connector at the printed circuit board.

One man calibration

All setup and maintenance is performed without opening the transmitter or declassifying the hazardous area. Tapping a magnetic wand at the three buttons through the window gives full access to the menu and the calibration procedure. No need for an additional handheld terminal.

DragerSensor technology

High sensitivity, long term stability and no false alarms are the hallmark of the new and improved third generation of sensors. Sensors are the keystones of any gas detection system. Fastest response to the target gas combined with minimal interference by other gases or environmental influences (no false alarms) as well as the sensor life-time determine the reliability and the operating cost of a system.



Features and Benefits

  Economical
  Non-intrusive calibration
  DragerSensor technology
  Simple software menu


Datasheet

Drager

Please note - Product designs and specifications are subject to change without notice. The user is responsible for determining the suitability of this product.

Back To Last Page